Introduction
This article explains how configure a Cisco device and record voice on an HTTP server.
Using the code
Shown here is a sample configuration for a Cisco device which is voice enabled on one port:
.
.
.
call application voice vxml flash:1:/http_rec.vxml
!
voice-port 0/0
supervisory disconnect dualtone mid-call
supervisory answer dualtone
pre-dial-delay 2
no battery-reversal
input gain 14
output attenuation -6
echo-cancel coverage 32
timeouts interdigit 2
timeouts call-disconnect 1
timeouts wait-release 3
!
!
!
!
dial-peer cor custom
!
!
!
dial-peer voice 100 pots
application vxml
incoming called-number .
direct-inward-dial
port 0/0
!
.
.
.
Now, create a VXML file for the Voice application (http_rec.vxml):
After that, you should create an ASP.NET project and add a record.aspx file to this project. I the code-behind, add this code in the Page_Load method:
Request.Files["myrec"].SaveAs(@"first.au");
Points of Interest
If you want to learn more about VXML, read: Cisco VoiceXML Programmer�s Guide.
History
- 21/05/2006: A simple voice recording on an HTTP server with a Cisco device.
